Grizzly G0820, Руководство пользователя, Страница: 34 / 104

-32-
Model G0820 (Mfd. Since 12/16)
50. On right side of crosscut fence, make sure 0°
stop block is against stop bolt, then secure
fence by threading M8-1.25 x 50 knob bolt
with (1) 8mm flat washer, and (2) M8-1.25
hex nuts into threaded hole on stop block, as
shown in
Figure 51.
52. If you installed splitter/riving knife earlier—
instead of riving knife—raise main blade all
the way up, and attach blade guard with (1)
M10-1.5 x 25 cap screw and (1) M10-1.5 lock
nut, as shown in
Figure 53.
53. Attach dust hose support to large extension
table with (1) M10-1.5 x 20 cap screw, (1)
10mm flat washer, and (1) M10-1.5 lock nut
(see
Figure 54).
Note: The support can be placed on either
the rear or side of the extension table using
the two available holes.
Figure 53. Blade guard installed onto splitter.
Figure 54. Dust hose support attached to rear of
large extension table.
Dust Hose
Support
Figure 51. Knob bolt threaded into 90° stop
block.
51. Attach flip stop (see Figure 52) by threading
knob bolt into T-nut previously installed in top
T-slot of fence.
Figure 52. Flip stop installed onto crosscut
fence.
Knob Bolt
Flip Stop
Stop Block
Knob Bolt