Grizzly G0772, Руководство пользователя, Страница: 60 / 124

-58-
Model G0772 (Mfd. Since 05/15)
Crosscutting Full-Size Panels
1. Install crosscut fence in front mounting loca-
tion shown in Figure 118.
Figure 118. Example of crosscut fence mounting
locations.
Rear Mounting
Location
2. Check to make sure fence is at 0°, and if nec-
essary, adjust it as described on
Page 84.
3. Adjust distance between crosscut fence and
blade (refer to Page 54 for further details).
4. Set either flip stop to desired width of cut.
Note: Extend the crosscut fence slide if
workpiece is more than 66".
5. Load workpiece onto table saw in front mount-
ing location (see Figure 115 on Page 57).
Front Mounting
Location
Determine which cutting operation will be best
suited for the workpiece to be crosscut.
— If you will be crosscutting full-size panels,
then skip ahead to
Crosscutting Full-Size
Panels.
— If you will be crosscutting smaller panels,
then skip ahead to
Crosscutting Smaller
Panels.
— If you will be crosscutting workpieces using
the rip fence as a cut-off gauge, then skip
ahead to
Crosscutting Using Rip Fence
as Cut-Off Gauge.
To understand how to move the crosscut table,
read
Positioning Crosscut Table Along Sliding
Table on Page 54.
Crosscutting Smaller Panels
1. Install crosscut fence in rear mounting loca-
tion shown in
Figure 118 and lock it in place.
2. Perform Steps 2–4 in Crosscutting Full-
Size Panels.
Note: Extend the crosscut fence slide if
workpiece is more than 66".
3. Load workpiece onto table saw in rear mount-
ing location, shown in Figure 116 on Page
57.
4. Take all necessary safety precautions, then
perform cutting operation.
6. Take all necessary safety precautions, then
perform cutting operation.
When set up properly, the crosscut fence can
support workpieces while using the rip fence as a
cut-off gauge, as shown in
Figure 117.
Crosscut Fence
Rip
Fence
Support
Bar
Workpiece
Figure 117. Crosscutting using the rip fence as
a cut-off gauge.