Grizzly G0772, Руководство пользователя, Страница: 59 / 124

Model G0772 (Mfd. Since 05/15)
-57-
4. Place fence in vertical position (see Figure
113) for thicker workpieces, or in horizontal
position for thinner workpieces and for angled
cuts where blade is tilted over fence.
Vertical
Horizontal
Figure 113. Example of rip fence positions.
5. Position leading edge of rip fence so it
extends across extension wing, as shown in
Figure 114, then retighten lock lever.
6. Lift rip fence lock lever (see Figure 114) and
adjust fence to approximate width of cut.
The crosscut fence mounts in the front or rear
position, although it is easier to load full-size pan-
els with the crosscut fence in the front position
(see
Figure 115).
Crosscutting
Figure 115. Crosscutting with fence mounted in
front position.
Workpiece
Mounting the crosscut fence in the rear position
(see
Figure 116) gives greater stability for cross-
cutting smaller panels.
Crosscut Fence
Workpiece
Figure 116. Crosscutting with fence mounted in
rear position.
8. Push rip fence lock lever down to secure
fence assembly in position.
9. Load workpiece onto table saw. Setup should
look similar to Figure 108 on Page 55.
10. Take all necessary safety precautions, then
perform cutting operation.
Figure 114. Proper position of rip fence.
Rip Fence
Micro-Adjust
Lock Knob
Rip Fence
Lock Lever
Micro-Adjust
Knob
7. Tighten micro-adjust lock knob (see Figure
114), then turn micro-adjust knob to fine tune
width of cut.