Grizzly G0772, Руководство пользователя, Страница: 37 / 124

Model G0772 (Mfd. Since 05/15)
-35-
55. Tighten each jam nut on all three rail studs
(see
Figure 56) to secure rail position against
tables.
59. Move sliding table all the way to the right.
Pull blade cover (see Figure 58) toward you
to open it. It is held closed with magnets and
just requires a firm tug to open.
54. Install inner hex nut on center stud under
table, then tighten hex nut until flat washer
just contacts table. Further tighten inner and
outer hex nuts on center stud with provided
wrench to avoid distorting rail.
60. Install riving knife (see Figure 58). Refer
to Riving Knife beginning on Page 44 for
detailed information.
Figure 58. Riving knife installed.
Blade Guard
Cover
Riving Knife
56. Lift rip fence base up and out of the way,
then install rip fence scale onto cast iron table
with (2) M6-1 x 30 flat head cap screws (see
Figure 57).
57. Install rip fence scale onto large extension
table with (2) M6-1 x 35 flat head cap screws,
(2) 6mm flat washers, (2) 6mm lock washers,
and (2) M6-1 hex nuts (see
Figure 57).
Figure 57. Rip fence scale installed.
x 2
x 2
Rip Fence Scale
58. Place rip fence base back on rail.
Figure 56. Location of rail stud jam nuts used to
secure rail position.