Grizzly G0772, Руководство пользователя, Страница: 58 / 124

-56-
Model G0772 (Mfd. Since 05/15)
3. Loosen slide lock lever shown in Figure 112.
Figure 112. Location of slide lock lever.
Slide Lock
Lever
Figure 111. Location of sliding table lock lever.
Sliding Table
Lock Lever
2. Lock sliding table in place with table lock
lever (see Figure 111).
Rip Cutting with Rip Fence
1. Move crosscut table and fence to front of slid-
ing table, and lock them in place with cross-
cut table lock lever (see
Figure 110).
Figure 110. Location of crosscut table lock lever.
Crosscut
Table Lock
Lever
5. Position blade guard according to height of
workpiece.
6. Load workpiece onto table saw. Setup
should look similar to
Figure 107.
7. Take all necessary safety precautions, then
perform cutting operation.
Figure 109. Location of flip stops and flip stop
knob bolts.
Flip Stops
Knob Bolts
4. Set a flip stop to desired width of cut (see
Figure 109) by loosening flip stop knob bolt,
sliding flip stop until it aligns with desired
mark on scale, and retightening knob bolt.
Rip Cutting with Sliding Table
1. Position crosscut fence on crosscut table
according to cutting operation (see Setting
Up Crosscut Fence on Page 53).
2. Check to make sure fence is at 0°. If nec-
essary, adjust it as described in Squaring
Crosscut Fence to Blade, on Page 84.
3. Calibrate crosscut fence (refer to Page 54 for
further details).