Grizzly G0772, Руководство пользователя, Страница: 23 / 124

Model G0772 (Mfd. Since 05/15)
-21-
Figure 11. Crate 1 inventory.
Inventory
Crate 1 (Figure 11) Qty
A. Saw Base Unit ............................................ 1
B. Small Extension Table ................................ 1
C. Large Extension Table ............................... 1
D. Crosscut Table Frame ................................ 1
E. Large Extension Table Brace (L) ................ 1
F. Large Extension Table Brace (R) ............... 1
G. Rip Fence Rail w/Fasteners ....................... 1
—Hex Nuts M20-2.5................................... 9
—Flat Washers 20mm ............................... 6
H. Rip Fence Base Assembly ......................... 1
I. Crosscut Fence Flip Stops ......................... 2
J. End Plate (Sliding Table) ............................ 1
K. End Handle (Sliding Table) ......................... 1
L. Push Handle ............................................... 1
M. Push Stick .................................................. 1
N. Flat Blade Guard Assembly ....................... 1
O. Bubble Blade Guard Assembly .................. 1
P. Blade Guard Swing Arm ............................. 1
Q. Blade Guard Lower Support Arm ............... 1
R. Blade Guard Upper Support Arm ............... 1
B
A
C
D
E
F
G
H
I
L
M
N
O
P
Q
R
K
J
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.