Grizzly G0772, Руководство пользователя, Страница: 30 / 124

-28-
Model G0772 (Mfd. Since 05/15)
15.
Install end plate onto rear (left) end of sliding
table with (2) pre-installed M5-.8 x 12 button
head cap screws and (2) 5mm flat washers
(see
Figure 26). Finish by installing (2) M6-1
x 15 cap screws, (2) 6mm conical lock wash-
ers, and (2) 6mm flat washers.
16. Install small extension table with (3) pre-
installed M8-1.25 x 20 hex bolts and (3) 8mm
flat washers, as shown in
Figure 27. Finger
tighten only, for now.
Figure 27. Underside view of small extension
table attached to cast iron table.
Figure 26. End plate installed on rear (left) end
of sliding table.
x 2
x 2
17. Place straightedge across cast iron table
and small extension table. Loosen hex bolts
shown in
Figure 28 and adjust small exten-
sion table as necessary to level it flush with
cast iron table. Final tighten hex bolts with
wrench.
Figure 28. Location of hex bolts used to level
small extension table.
Figure 29. Underside view of large extension
table attached to cast iron table.
18. Install large extension table with (4) pre-
installed M8-1.25 x 20 hex bolts and (4) 8mm
flat washers (see
Figure 29). Use straight-
edge to verify extension table and cast iron
table are flush, then tighten bolts.