Deck System Resistance Test Procedure
7
If no issues are found, reinstall deck controller
wire connections to the proper torque values loca-
ted in the service and repair manual. (See page
28)
8
Measure deck motor resistance (
Ω): (A) Place the
negative (-) probe of a digital multimeter on mo-
tor terminal A. (B) Place the positive (+) probe of
thed igital multimeter on motor terminals B, then
C. If the resistance is more than o to 1 (
Ω )ohms
the deck motor will need to be replaced. Repeat
process for other deck motor as needed.
9
Measure the resistance in the six-pin motor con-
nector by placing the negative (-) probe of a digi-
tal multimeter on pin 2 and the positive (+) probe
on pin 3. Resistance should read between
800k(Ω) and 1.2m (Ω) ohms. Resistance between
pin 2 and pins 1,4,5 and 6 should be 0 ohms. If
resistances are above or below these ranges, the
deck motor will need to be replaced. Repeat the
process for the other motor as needed.
10
If steps 1-9 are completed and the issues persist,
please refer to the mower manufacturer's proce-
dure for wiring harness troubleshooting for possi-
ble repair or replacement.
15
TECHNICAL DATA
Model No.
2522
302
2522
202
7405
302
7403
102
7405
202
7405
102
Gross vehicle
weight
1433” 1285” 1433” 1285” 1285” 1433”
Length over-
all
79.1” 79.1” 79.1” 79.1” 79.1” 79.1”
Width overall
(with dis-
charge)
73.2” 65”
73.2” 73.2” 65”
65”
Height over-
all
48.5” 48.5” 48.5” 48.5” 48.5” 48.5”
Deck width
60”
50”
60”
60”
52”
52”
Forward
speed
0-10
mph
0-10
mph
0-10
mph
0-10
mph
0-10
mph
0-10
mph
Reverse
speed
0-3.1
mph
0-3.1
mph
0-3.1
mph
0-3.1
mph
0-3.1
mph
0-3.1
mph
Cutting
height range
"1-5.
5"
"1-5.
5"
"1-5.
5"
"1-5.
5"
"1-5.
5"
"1-5.
5"
35
English
EN
P0802464-00 v1.2