Check mower safety start interlock system daily, prior to
operation. This system is an important mower safety feature.
It should be repaired immediately if it malfunctions. Call
Greenworks Commercial immediately. The machine
incorporates a separate seat switch which will stop the drive
system and deck motors when the operator is unseated for any
reason while the mower is operating. This is a safety feature
designed to prevent runaway or accidental entanglement.
WARNING
The safety interlock system must not be disconnected or
bypassed. Doing so could cause the machine to operate
unexpectedly, resulting in personal injury.
To inspect the system:
1. The operator must be on the seat when testing the seat
switch.
2. Turn the master power ignition switch to the ON position
with key.
3. Keep steering control levers in neutral position.
4. Pull the deck blades ON and OFF switch to engage the
motor.
5. Slowly raise off of the seat. The deck blade system should
stop.
6. If the deck blade system fails to stop when the operator is
off of the seat and if the cause cannot be
determined,contact your Greenworks dealer immediately.
7.4
ROPS (ROLL OVER PROTECTIVE
STRUCTURE)
A ROPS may minimize the chance of injury or death from
rollover. The two-post ROPS can be pivoted down by
removing the clevis pins (21) after pulling out on the R-pins
(22) so that the machine can operate under low-hanging tree
limbs or other obstructions. Do not wear the seat belt when
the ROPS is in the lowered position. Use the ROPS in the
“folded” position only when it is absolutely necessary.
WARNING
Do not operate the mower with the ROPS folded (lowered
position) -- a standard operating mode. A folded ROPS does
not provide rollover protection.
WARNING
Always wear your seat belt unless the ROPS is folded
down. In this case, the seat belt should never be worn.
WARNING
To minimize chance of injury or death from rollover:
•
Keep ROPS in the raised and locked position and use
the seat belt.
•
Lower the ROPS only when absolutely necessary.
•
Drive slowly and carefully. Raise the ROPS as soon as
clearance permits. Read and follow slope operation
instructions and warnings.
•
Always fasten seat belt during operation of the machine
(mower equipped with ROPS in “raised/up” position).
•
Inspect the area to be mowed for proper overhead
clearance (tree limbs, guy wires, doorways, etc.) Do not
contact any overhead object with the ROPS.
WARNING
Always pull from the tractor hitch. Do not attach chains or
ropes to the ROPS for pulling purposes, as the machine can
tip backwards.
7.5
ANTI-SCALP WHEELS
Anti-scalp wheel kits are standard on Greenworks
Commercial units. These anti-scalp wheels (23) are designed
to minimize scalping when mowing on rough, uneven terrain.
After setting the cutting height, adjust the anti-scalp wheels
so they extend below the deck but do not contact the ground.
They should always be at least 1/4" to 3/4" below the deck.
With the unit sitting on a flat level surface, the wheel position
can be adjusted up or down as needed from 3/4" to 1-3/4"
below the blade surface. Move the wheels up or down - using
the different axle mount holes in the wheel mount bracket (if
applicable on model).
7.6
NEUTRAL BYPASS KNOB
1. Locate the Neutral Bypass Knobs behind the frame at the
rear of the mower.
2. Remove the (4) thumb screws (24) holding in the mesh
cover.
9
English
EN
P0802464-00 v1.2