A/B
4.1
Throttle Wiper High
Throttle failure
1. See Monitor menu » Inputs: Throttle Pot.
2. Throttle pot wiper voltage too high.
3. Bring throttle pot wiper voltage below the
fault threshold.
A/B
4.2
Throttle Wiper Low
Throttle failure
1. See Monitor menu » Inputs: Throttle Pot.
2. Throttle pot wiper voltage too low.
3. Bring throttle pot wiper voltage above the
fault threshold.
A/B
4.3
Pot2 Wiper High
Throttle failure
1. See Monitor menu » Inputs: Pot2 Raw.
2. Pot2 wiper voltage too high.
3. Bring Pot2 wiper voltage below the fault
threshold.
A/B
4.4
Pot2 Wiper Low
Throttle failure
1. See Monitor menu » Inputs: Pot2 Raw.
2. Pot2 wiper voltage too low.
3. Bring Pot2 wiper voltage above the fault
threshold.
A/B
4.5
Pot Low Overcurrent
Throttle failure
1. See Monitor menu » Outputs: Pot Low.
2. Combined pot resistance connected to pot
low is too low.
A/B
4.6
EEPROM Failure
Download the correct software
(OS) and matching parameter
default settings into the control-
ler and cycle KSI.
Download the correct software (OS) and match-
ing parameter default settings into the controller
and cycle KSI.
A/B
4.7
HPD/Sequencing Fault Reapply input s in correct
sequence.
1. KSI, interlock, direction, and throttle inputs
applied in incorrect sequence.
2. Faulty wiring, crimps, or switches at KSI,
interlock, direction, or throttle inputs.
3. See Monitor menu » Inputs.
A/B
4.7
Emer Rev HPD
Reapply input s in correct
sequence.
At the conclusion of Emergency Reverse, the
fault was set because various inputs were not
returned to neutral. If EMR_Interlock = On, clear
the interlock, throttle, and direction inputs. If
EMR_Interlock = Off, clear the throttle and
direction inputs.
A/B
4.9
Parameter Change Fault Cycle KSI.
This is a safety fault caused by a change in
certain parameter settings so that the vehicle will
not operate until KSI is cycled.
A/B
5.2
Slave PDO Fault
Cycle KSI
Time between CAN PDO messages (between
Master controller and Slave controller) received
exceeded the PDO Timeout Period.Check the
communcation wires from slave controller.
A/B
5.3
Master or Slave HPD
Fault
Reapply inputs in correct
sequence.
1. KSI, park switches ,PTO switch and throttle
inputs applied in incorrect sequence.
2. Faulty wiring, crimps, or switches at KSI, park
switches and throttle inputs.
A/B
5.4
Battery BMS Fault
Check the battery voltage , If
battery is low, recharge; Restart
vehicle; Replace battery and
contact dealer
Check the battery voltage , If battery is low,
recharge; Restart vehicle; Replace battery and
contact dealer.
19
English
EN
P0802464-00 v1.2