9
M_LS1000 XP_EN_C
E. Introduction
1. Presentation
The LS1000 XP is an engraving, marking and cutting machine equipped with a CO2 laser source.
The 40W/60W/80W laser sources are air cooled.
The 100W/150W laser sources are water cooled. A water chiller is supplied.
This type of laser offers very high quality marking on a wide range of materials.
2.
Identification of the marking equipment
The marking equipment is identified by:
•
1 identification plate on the rear face
Have the model and serial number of the equipment available when contacting Gravotech.
3.
Work station safety
•
Turn off the machine before beginning any cleaning, maintenance or repair procedure.
•
Never operate the machine near a cardiac pacemaker.
•
Never operate the machine without the protective covers properly mounted.
•
Never operate the machine if the doors are damaged or do not close properly.
Air extraction system
•
Never operate the machine without a fume and gas extraction system that is properly configured,
installed and maintained in good working order.
•
The gases and fumes from the marking process must be extracted from the machine and discharged
outside.
