55
M_LS1000 XP_EN_C
Using the machine
11.
Removing and reloading material
The laser beam is shut off once the machine has finished processing the material. The head goes back to the
origin (top left corner).
Before opening the door, wait a few seconds for any remaining fumes emitted during the marking or cutting
process to be removed by the extraction system. In the L-Solution driver, it is possible to enter a timeout value
to set a delay before the air extraction system stops when marking is finished.
Open the front door. Remove the material.
The collection tray allows cut pieces to be recovered.
1.
Collection tray
2.
Cutting table
Load the next material. If it is the same material as the one before and the same file is being executed, close
the door. Start-up engraving: Press the key.
1
2
