65
M_LS1000 XP_EN_C
Preventive maintenance
7. Setting point zero (Origin)
The screen below appears:
L01 SETUP
FPGA
X.X
The machine emits an audible signal. The following screen is displayed for 3 seconds:
<< GRAVOGRAPH >>
FPGA
X.XX
LCD
SOFT
X.XX
32
Mo
BOOT
X.XX
1. While this screen is displayed, press the key:
2. Select the following menu:
LASER SETTINGS
TICKLE
RE-ALIGN MACHINE
USING TIME XXX
3.
To confirm, press the key:
4. Select the following menu:
X-Y ADJUSTMENT
Z ADJUSTMENT
ALIGNMENT MODE
5.
To confirm, press the key:
The head goes back to the origin (top left corner). The pointer is lit (Red).
The screen below appears:
X-Y ADJUSTMENT
JOYSTICK X-Y
X
X.XX Y
X.XX
6. Position a plate on the table (top left corner).
7. Set the laser pointer to the top left corner of the plate (Up - Down - Left - Right arrows).
8. Press the key.
Keep the key(s) pressed until the head returns to the origin (top left corner).
