Graco Therm-O-Flow Plus, Инструкция по эксплуатации

Страница: 5 / 82

5 309085
WARNING
FIRE, EXPLOSION AND ELECTRIC SHOCK HAZARD
Improper grounding, poor air ventilation, open flames, or sparks can cause a hazardous condition
and result in fire, explosion, or electric shock and other serious injury.
Ground the equipment, the object being dispensed to, and all other electrically conductive
objects in the dispense area. See
Ground the System on page 13.
Do not use this equipment with flammable fluids.
Do not stop or deflect fluid leaks with your hand, body, glove, or rag.
Keep the dispense area free of debris, including solvent, rags, and gasoline.
If there is any static sparking or you feel an electric shock while using the equipment, stop dis-
pensing immediately. Do not use the equipment until you have identified and and corrected
the problem.
Provide fresh air ventilation to avoid the buildup of flammable fumes from solvent or material.
Do not smoke in the dispense area.
Extinguish all open flames or pilot lights in the dispense area.
Make sure all electrical equipment is installed and operated in compliance with applicable
codes.
Make sure power is disconnected when servicing and repairing equipment.
Have any checks, installation, or service to electrical equipment performed by a qualified electri-
cian only.
Never exceed the maximum wattage of the supply unit. See the wiring diagrams in this manual
for more information.
Only use hoses that have a maximum wattage less than an equal to 1250 watts. Using hoses
with higher maximum wattage could create a runaway temperature condition.
MOVING PARTS HAZARD
Moving parts, such as the ram plate and pump inlet, can pinch or amputate your fingers.
Moving equipment parts can cause personal injury, including severing of hands or fingers.
Make sure all personnel are clear of moving parts before operating the equipment.
Keep clear of all moving parts when starting or operating the equipment.
Keep hands and fingers away from the priming piston during operation and whenever the pump
is charged with air.
Keep clear of the ram plate, pump fluid inlet, and lip of the fluid container when raising or lower-
ing the ram.
Before checking or servicing the ram or pump, follow the Pressure Relief Procedure on page
23.