GMG 1330-ED, Руководство по обслуживанию

Страница: 57 / 70

TS200
Section 5 - Procedures
5.3-3 TS200 Menu Table with EZcal
When the EZcal hand-held device is connected to
the TS200 control module, a two line display shows
various menus and settings. At any time the top line of
the display describes the currently selected menu and
the bottom line shows the currently selected item in
that menu.
Six buttons on EZcal allow easy navigation through
the menus:
+- and -+ change the selected item (the bottom line
display)
ENTER enters the selected new menu when available
(top line display changes)
t
and .J. adjusts the selected item when available (at
'�CCESS LEVEL'.' 2)
ESC exits the current menu back to the previous
menu
TS200 Menu Table with EZcal
HELP
DIAGNOSTICS
ACCESS LEVEL
RUN SYSTEM TEST
ADJUSTMENTS
SETUPS
CALIBRATIONS
SERIAL NUMBER
(help message)
LOGGED HELP
Select this menu to see a description of current TS200 status
Select this menu to see switch & sensor input status & logged data
Select this menu & enter correct code to enable adjustments and calibrations
Select this menu to enter system test mode
Select this menu to see and adjust TS200 adjustments
Select this menu to carry out initial set-up of the TS200
This menu is intended for use by TS200 design engineers only!
Select this menu to view the serial number of the controller
HELP
A message displays current TS200 status, indicating if everything is OK or if there is a reason for restricted
functionality
Press ENTER when viewing the current HELP message to see a log of recent HELP messages; press
e
to see
older messages, and i, to see newer ones; press ESC to return to the current HELP message
57
1330ED
&
1530ED micro
GMG