GMC 1989 Light Duty Truck, Руководство по ремонту, Страница: 678 / 998

6P4-6 PG-200 (PMGR) STARTING MOTOR
A. In s ta lla tio n D ire c tio n
F-05841
Figure 11— Gear Bearing Installation
A. In s ta lla tio n D ire c tio n
F-05842
Figure 14— Forcing the Stop Ring on the Shaft
Figure 12— Drive End Bearing Installation
F-05845
Figure 13— Arm ature, Gears and Drive
3. Gear bearing into the gear by pressing until it is 0.28
to 0.38 mm (0.011 to 0.014 inch) below the casting
surface (figure 11).
• Lubricate the bearing with lubricant PN 10497186 or
Figure 15— Forcing the Collars over the Stop Ring
equivalent if needed. This gease m aintains lubricat­
ing qualities even at tem perature extrem es.
4. Drive end bearing into the drive housing assem bly
(figure 12).
• Press the bearing until it is 0.25 to 0.45 mm
(0.009 to 0.010 inches) below the casting face.
• Add lubricant PN 10497186 or equivalent to the
bearing.
5. Lubricant PN 10497186 or equivalent to the inner
gear teeth, planetary gears, arm ature shaft gear
teeth, and the shaft assem bly bearing (figure 13).
6. Inner gear and drive over the shaft.
7. Stop collar (39) onto the shaft.
8. Stop ring (37) on the shaft (figure 14).
• Place the ring on the end of the shaft.
• With a wood block on the top of the ring, force
the ring onto the shaft with a light ham mer blow.
• Slide the ring down and into the shaft groove.
Do not distort the retainer ring when installing it.
9. Thrust collar (81) onto the shaft.
• Use pliers to squeeze the collars over the stop ring
(figure 15).
10. Drive and shaft assem bly into the drive housing
assembly.