Chapter 2 — Installing a New Cabinet
©2007 Global VR, Inc.
040-0168-01 Rev. B 3/14/2008
Page 7 of 64
Chapter 2
— Installing a New Cabinet
Cabinet Installation
Use the following procedure to install and set up your game:
1.
Carefully remove the Main Cabinet and Seat Cabinet from the shipping boxes, giving yourself
plenty of space. Inspect the exterior of the cabinets for any damage.
2.
Remove the keys from the coin return slot. Open the coin door to locate the second set of keys.
Figure 2.
Coin Door with Key Location
3.
Locate the following items (small hardware items should be in the coin box):
•
Two (2) Connector Brackets
•
Two (2) Wing Assemblies
•
28 ¼-20 x 1-¼" bolts
•
12 each Flat Washers & Lock Washers
•
16 1" Fender Washers
•
AC Power Cord
4.
Locate the following documents and software:
•
System Manual (This Document)
•
Software Restore Guide
•
System & Game Install Disk
5.
Move the Main Cabinet and Seat Cabinet so they face each other, about 12-inches apart.
6.
Locate the Five (5) cables tied inside the area under the floor of each cabinet and connect the
corresponding connectors.
•
4-Pin PC Power (Rear Marquee Power)
•
2-Pin Molex (Knocker Control)
•
3-Pin Molex (Ground Wires)
•
6-Pin Molex (Special Lighting)
•
15-Pin Molex (Player Controls)
7.
Carefully push the Main Cabinet and Seat Cabinet together, being careful not to pinch any
cables.
8.
Connect the AC power cord from the AC Power Plate on the back of the cabinet to a grounded
(3-terminal) AC wall outlet.
