Chapter 6 — Service and Repair
Blazing Angels Operation and Service Manual
Page 36 of 64
040-0168-01 Rev. B 3/14/2008
5.
Remove the four (4) bolts that secure the monitor backbox to the mounting brackets inside the
cabinet. The picture below shows the locations of the bolts inside the cabinet
Figure 23.
Monitor Mounting Bolts
6.
Carefully lift the monitor, bezel, and glass out of the cabinet as one unit. This is easiest to do
with a person on each side of the assembly.
7.
Place the LCD monitor assembly
face down
on a safe working surface. (
Do not
set it on the
PCB.)
The wire harnesses between the PCB and LCD panel are VERY
FRAGILE. Use extreme care when disconnecting or connecting them.
8.
Refer to Figure 24 for monitor assembly components.
Carefully
disconnect the three wire
harnesses that connect the LCD panel to the LCD Control PCB on the back of the assembly.
Figure 24.
Monitor and Backbox Components
9.
Remove the seven (7) screws that secure the bezel in place around the front of the monitor.
10.
Remove the four (4) bolts from the back of the backbox (shown by the circles in Figure 24) and
lift off the backbox with the attached LCD Control PCB.
11.
Lift the LCD panel out of the bezel.
