Chapter 6 — Service and Repair
©2007 Global VR, Inc.
040-0168-01 Rev. B 3/14/2008
Page 41 of 64
Figure 27.
Marquee Assembly Exploded View
Exhaust Port LED Service
The Exhaust Ports on the side of the cabinet are lit by two 12" red LED tubes. Do the following
to replace a light tube:
1.
Remove the six (6) Torx screws with flat washers that secure the molded plastic exhaust port
cover in place.
2.
Remove the two screws that secure the clear plastic piece in place under the molded plastic
cover. The LED tube is secured to the plastic piece with two cable ties.
3.
Carefully pull the power wires to bring the connector out of the cabinet. Disconnect the light and
connect the new light. Push the connector back through the hole into the cabinet.
4.
Snip the cable ties and secure the new light tube to the plastic piece with new cable ties.
5.
Reverse the removal steps to replace the components on the cabinet.
Front Instrument Panel LEDs
The Front Instrument Panel is lit by four 6" and two 12" white LED Light Tubes. Each light is
held in place with two screw-mounted cable ties.
To access the lights, remove the 12 Torx screws that secure the instrument panel artwork and
clear plastic in place and remove the plastic and artwork.
Side Instrument Panel LEDs
Each Side Instrument Panel is lit by a two 12" white LED Light Tubes.
To access the lights, remove the six (6) Torx screws that secure the clear plastic and artwork in
place and remove the plastic and artwork.
