Chapter 6 — Service and Repair
©2007 Global VR, Inc.
040-0168-01 Rev. B 3/14/2008
Page 29 of 64
2.
Make a note of the orientation of the pot. The pot has a small metal tab (key) that fits into a
small hole in the plate.
3.
Remove the 5/64" Allen screw from the gear wheel and remove the gear wheel.
4.
Remove the 1/2" nut and lock washer from the shaft and remove the pot.
5.
Make a note of which wire is soldered to each terminal, and be sure to solder them to the same
terminals on the replacement pot.
6.
Reverse the removal steps to re-install the pot and gear wheel. Be sure to install the pot with the
key in the hole in the plate.
Figure 17.
Throttle Pot and Gear Assembly
Replacing the Throttle Handle
See page 54 for an exploded view drawing. To remove the handle from the throttle, note the
orientation of the handle for reassembly and remove the 3/16" Allen screw, shown below.
Thread the throttle button wires out through the hole.
Figure 18.
Replacing the Throttle Handle
