43
P U S H - T O - O P E N
© G h o s t C o n t r o l s
®
2 0 2 1
STEP 5.
Drilling rear post bracket holes and bolting.
A. With the post bracket still clamped to post, mark the center of the bracket slots. Remove the bracket.
B
.
You will need a 13/32˝ drill bit to drill the (4) holes to mount the rear post bracket to the post.
TIP:
Drill each hole one at a time and insert a bolt through to ensure that the holes are large enough and all aligned.
C. Insert (1) M-10-175mm bolt, and (1) flat washer through the rear post bracket hole on the post and secure on
backside with (1) flat washer and (1) M10 locknut as shown and loosely tighten to secure the rear bracket to
the post. Repeat this 3 more times for the other bolts. Once all 4 bolts are in place, with the bracket aligned
with the bolts in the center of the slots, firmly tighten all four bolts.
STEP 6.
Install rear of operator on rear post mount.
Insert clevis pin, nylon spacer, and clevis hairpin as shown below to secure the rear of the operator to the post.