32
P U L L - T O - O P E N
© G h o s t C o n t r o l s
®
2 0 2 1
B. Install the front mount gate bracket on the gate by aligning the outermost hole and inserting (1) M8 x 65mm
flat washer, and (1) M8 nylon locknut through gate and front mount bracket, as show below. Tighten to secure
the brackets to the gate.
MAKE SURE GATE IS STILL IN OPEN POSITION (arm must be fully retracted).
Front Mount Bracket
C. Disconnect operator from front mount gate bracket and swing away from the gate.
D. Assemble clevis pin, front spacer and hair pin to operator to prevent loss.
E. Now you can mark and drill the innermost hole on the front mount bracket, shown below.
Mark and drill the center location of
the innermost hole for the Gate Bracket
CL
F. Align the innermost hole of the gate bracket and insert (1) M8 x 65mm flat washer,
and (1) M8 nylon locknut through both holes and tighten to secure the bracket
to the gate.
YOUR FRONT MOUNT GATE BRACKET SHOULD NOW BE
ATTACHED AND SECURED TO THE GATE.
Remove the clevis pin,
hair pin, and front spacer.
