GGP ITALY TC 102-122, Руководство пользователя

Страница: 77 / 124

17
PROBLEM LIKELY CAUSE SOLUTION
3. With the key on «START» the
dashboard comes on but the
starter motor does not run
– insufficiently charged battery
– battery charger fuse blown
– recharge the battery (see 6.2.3)
– replace the fuse (25 A) (see
6.3.5)
4. With the key on «START» the
starter motor runs but the engine
does not start
– insufficiently charged battery
– faulty fuel supply
– faulty ignition
– recharge battery (6.2.3)
– check the level in the tank
(see 5.3.3)
– open the fuel stopcock (if fitted)
(see 5.4.1)
– check the fuel filter
– check that spark plug cap is
securely fitted
– check that the electrodes are
clean and have the correct gap
5. Starting is difficult or the engine
runs erratically
– fault in carburetion – clean or replace the air filter
– flush out the float chamber
– empty the fuel tank and refill with
fresh fuel
– check and replace the fuel filter if
necessary
6. Weak engine performance
during cutting
– forward speed too high in relation
to cutting height
– reduce the forward speed and/
or raise the cutting height (see
5.4.5)
7. Engine stops when cutting
means are engaged
– you are not ready to engage the
blade
– check that all starting conditions
are met (see 5.2.)
8. The battery warning light does
not turn off after a few minutes’
work
– recharging of the battery
insufficient
– contact your dealer
9. The oil warning light comes on
while working(if fitted)
– problems in lubricating the
engine
– Turn the key immediately to
«OFF»:
– top up the oil level (see 5.3.3)
– replace the filter (if the problem
continues, contact your dealer)
10. The engine stops and an
audible signal is heard
The safety device of the electronic
circuit board has cut in due to:
– overvoltage caused by the
charge regulator
– badly connected battery (poor
contact)
Turn the ignition key to the «OFF»
position
and look for the cause of the
problem:
– contact your dealer
– check connections (see 3.4)
11. The engine stops with no
audible warning
– disconnected battery
– problems in the engine
– check connections (see 3.4)
– contact your dealer
12. The cutting means do not
engage or do not stop promptly
when they are disengaged
– loose belt
– problems in the electromagnetic
clutch
– contact your dealer
– contact your dealer
13. Uneven mowing and poor
grass collection
– cutting means assembly is not
parallel to the ground
– inefficient cutting means;
– forward speed too high
compared to the height of grass
being cut
– collector channel is blocked
– check the tyre pressure (see
5.3.2)
– reinstate the alignment of the
cutting-means assembly in
relation to the ground (see 6.3.1)
– contact your Dealer
– reduce the forward speed and/
or raise the cutting-means
assembly (see 5.4.5)
– wait for the grass to dry
– remove the grass catcher and
empty the collector channel (see
5.4.7)