GF CNC 4.0 400, Инструкция по эксплуатации

Страница: 87 / 200

Operating instructions CNC 4.0 400/500/630 12 Error/Warning messages
81
Message
Display
page
Meaning Possible causes Actions
Temp. low! START
FUSION
PROCESS
Heating plate
temperature is
lower than the
set value.
It’s not possible
to get the next
process step.
1) Not enough
time passed
to complete
warming up
(less than 20
min)
2) Not enough
power to
heating
element
1) Wait to complete
warming-up
2) Check input
voltage from
generator or
mains
Temp. high!
START
FUSION
PROCESS
Heating plate
temperature is
higher than
the set value.
It’s not possible
to get the next
process step.
Set temperature
has been
switched to a
lower value
(e.g. welding
standard
changed).
Wait for cooling
down to set
temperature.
ERROR OCCURRED!
BEAD
BUILD UP
/
HEAT SOAK
TIME
/
COOLING
TIME
A welding
parameter
(pressure,
heater
temperature,
time) went out
the tolerance
range: an error
will be
reported in the
fusion
protocol.
Check the ERROR
CODE on the display
after welding
(chapter 10.2.3) or
the fusion protocol
for further analysis.
Get in contact with
GF after- sales
service if necessary.
CARRIAGE OPENED
DURING HEATING
TIME
Dedicated
page.
The base
machine
carriage
moved to
opening
direction
during the
HEAT SOAK
TIME.
Pulling force
exerted by
gravity: the
pipeline is set on
a high slope, so
that it
overcomes the
frictional
resistance.
- Set the working
area on a more
gentle slope
- Reduce the length
of the pipeline
clamped on the
mobile carriage
- Keep the mobile
pipeline stable
during the heating
soak time