GF CNC 4.0 400, Инструкция по эксплуатации

Страница: 12 / 200

3 General Operating instructions CNC 4.0 400/500/630
6
3 General
3.1 Introduction
This instruction manual was written for those persons responsible for the
operation and care of the CNC 4.0 400/500/630. It is expected and
assumed that such persons have read, understood and will abide by
the manual in its entirety.
Only with the knowledge contained in this manual can faults on the
CNC 4.0 400/500/630 be prevented and trouble-free operation be
ensured. It is therefore imperative that the responsible persons are
familiar with this manual.
We recommend that this manual be read carefully prior to putting the
machine into operation, as we are not liable for any damage or
interruptions in operation resulting from failure to comply with this
manual.
Should problems nevertheless arise, please contact Georg Fischer
Omicron s.r.l. directly or the nearest service representative.
This manual applies only to the CNC 4.0 400/500/630 butt-fusion
machines.
We reserve the right to make technical changes necessary to improve
the CNC 4.0 400/500/630 which may result in deviations from the
illustrations and information contained in this manual.
3.2 Range of application
The CNC 400/500/630 4.0 are designed exclusively for the fusion of pipes
and fittings made of thermoplastics (PE, PP, PB) according to the
specified dimension range. Any other use is not authorized. The
manufacturer cannot be held liable for damages resulting from
unauthorized use; the user bears sole responsibility.
CNC 4.0 400: Ø125 – Ø400 mm;
CNC 4.0 500: Ø200 – Ø500 mm;
CNC 4.0 500: Ø315 – Ø630 mm;