GF CNC 4.0 400, Инструкция по эксплуатации

Страница: 35 / 200

Operating instructions CNC 4.0 400/500/630 8 WELDING
29
Danger of crushing hands!
Machine slide moves!
Danger of injury inside the moving machine carriage!
When moving to the end positions do not reach into the machine.
Start the action by touching the button , then the display changes
automatically into the following page:
The machine carriage moves slowly until the pipes are in contact. The
calculation of the drag pressure is executed during the movement. The
machine opens automatically again after the measurement and the
display moves to the next page.
To stop the process immediately push the button . After this action
the CLAMP PIPES & ALIGNMENT page will appear to enable to move the
carriage!
If the drag pressure is higher than the welding pressure, check if the
pipes are properly supported by rollers and repeat the measurement of
drag pressure. The machine will allow to weld even in this condition!
8.2.5 Pipe planing
Warning
Attention
Suggestion