GF CNC 4.0 400, Инструкция по эксплуатации

Страница: 40 / 200

8 WELDING Operating instructions CNC 4.0 400/500/630
34
Check the pipe ends according to the following guidelines:
The gap must not be larger than 0.5 mm.
Check wall offset at the same time. The wall
offset on the outside must not exceed 10% of the
wall thickness. If it is larger, the wall offset can be
reduced by adjusting the clamping unit or by
changing the clamping force using the
clamping screws.
If pipes are properly aligned, confirm by pushing the button OK: the
carriage opens automatically and the display moves to the next page.
If not, push the button to get back to the CLAMP PIPES &
ALIGNMENT page to adjust the pipe position and restart the complete
procedure.
To get a correct alignment of the pipes, use roller supports (at least 1
roller support per pipe)!
To stop the process immediately push the button . After this action
the CLAMP PIPES & ALIGNMENT page will appear to enable to move
the carriage!
If the pipe slides, a specific message appears.
Attention
Advice
Attention
Attention