GESTRA TK 23, Оригинальная инструкция по установке

Страница: 23 / 64

23
Attention!
Equipment may leak if the gasket is
damaged.
 Replace all gaskets that you loosen
during your work.

Use only new gaskets of the same
type.

Put the new inner gasket (26) onto the
adjustment screw.

Put the hexagon nut (25) onto the adjustment
screw (9).

Make sure that the adjustment screw cannot
rotate.
For this purpose you can for example push the tip
of a screwdriver into the slot of the adjustment
screw.
 Tighten the hexagon nut (25) with a torque of
30 Nm.

Put the new outer gasket (26) onto the
adjustment screw.

Screw the cap nut (1) onto the adjustment
screw.

Tighten the cap nut with a torque of 30 Nm.
 Insert the new gasket (27) into the bore of the
sealing plug.
 Put the sealing plug (10) into the bore.
The torque for the sealing plug depends on the
equipment type.

Equipment of type TK 23 requires a torque of
30 Nm.

Equipment of type TK 24 requires a torque of
40 Nm.

Fasten the sealing plug with the specified
torque.