GESTRA TK 23, Оригинальная инструкция по установке

Страница: 32 / 64

32
Attention!
Equipment may leak if the gasket is
damaged.
 Replace all gaskets that you loosen
during your work.

Use only new gaskets of the same
type.

Put the new inner gasket (26) onto the lower
adjustment screw (12).

Put the hexagon nut (25) onto the adjustment
screw.

Make sure that the adjustment screw cannot
rotate.
For this purpose you can for example push the tip
of a screwdriver into the slot of the adjustment
screw.
The torques required for tightening the hexagon nut
(25) and the cap nut (1) depend on the equipment
type.

TK 23 requires 20 Nm.

TK 24 requires 30 Nm.
 Fasten the hexagon nut with the specified
torque.
 Put the new outer gasket (26) onto the lower
adjustment screw.
 Screw the cap nut (1) onto the adjustment
screw.
 Fasten the cap nut with the specified torque.

Put a new gasket (27) over the thread of the
sealing plug.

Put the sealing plug (10) into the bore.
The torque for the sealing plug depends on the
equipment type.

TK 23 requires 20 Nm.

TK 24 requires 40 Nm.
 Fasten the sealing plug with the specified
torque.