GESTRA TK 23, Оригинальная инструкция по установке

Страница: 53 / 64

53
CAUTION
Danger of bruising if the equipment falls
down.
 When removing the equipment make
sure the it is safely held in place and
cannot fall down.
Suitable measures are for instance:

Equipment that is not too heavy may be
supported by a second person.

For heavy equipment use suitable lifting
equipment of sufficient strength.
 Detach the end connections of the equipment
from the pipes.
 Put the equipment onto a suitable base.

Store the equipment as described in section
"Storing the equipment"
from page 11
onwards.
Re-using equipment after storage
Observe the following instructions if you want to
remove the equipment and use it again somewhere
else:

Make sure that the equipment is free of any
fluid residues.

Make sure that all connections are in good
condition and leak-free.
 Use the equipment only for its intended purpose
and the service conditions for which it was
specified.
Disposing of the equipment
Caution
Environmental damage may be caused by
poisonous fluid residues.

Before disposing of the equipment
make sure that it is clean and free of
fluid residues.
 For the disposal of all materials
observe the pertinent legal regulations
concerning waste disposal.
The equipment is made from the following
materials:
Component part EN number ASTM
Body and cover
TK 23 5.1301 A126B
Body and cover
TK 24 1.0619 A216WCB
Bolts TK 23, TK 24
DN50 1.7709 –
Bolts TK 24 DN65–
100 1.7225 A193 B7
Gasket Graphite/CrNi
Membrane
regulator capsule Hastelloy
®
/Stainless steel
Other internals Stainless steel
The equivalent ASME material
specifications are stated for guidance only.
Physical and chemical properties of the
materials can therefore differ from the
ASME specification for materials.

For more details please contact the
manufacturer.