33
Chapter Three:
Adding Output Devices
Whether installing OMEGA 2.6 for the first time or upgrading your software, you may need to
add output devices. The Add or Delete Plotters/Routers, Add or Delete Vinyl Printers, or Add
or Delete ImageRIP Printers dialog boxes enable you to install the output devices. You can
access these dialog boxes three different ways:
1
During installation of OMEGA 2.6 by turning on the Install Printers/Plotters checkbox
located on the final installation screen.
2
By clicking right on the GSPTray icon that is found at the bottom right of your
Windows status bar and choosing Install Vinyl Printer, Install Plotter/Router, or
Install ImageRIP Printer.
3
By clicking Start > Programs > GSP OMEGA > GQMgr > Install menu > Plotter, Vinyl
Printer, or Ink Jet Printer.
These procedures are described in the following pages:
♦
To add output devices after installing OMEGA 2.6 software
♦
To add or delete a local vinyl printer (parallel and USB-to-Parallel)
♦
To add or delete a remote vinyl printer
♦
To add or delete a network vinyl printer
♦
To add or delete a local inkjet printer
♦
To add or delete a remote inkjet printer
♦
To add a local plotter via a COM port
♦
To install a plotter via a USB port
♦
To delete a local plotter
♦
To add or delete a remote plotter
Adding output devices after OMEGA installation
To add output devices after installing OMEGA software
1
Turn on Install Plotters/Printers checkbox in the OMEGA Setup Complete dialog box
to open the Add or Delete Gerber Vinyl Printer(s) dialog box.
2
If you are installing a vinyl printer use one of the procedures in “Installing vinyl
printers.” If you are not adding a vinyl printer, click Close to display the next device
installation dialog box – either Add or Delete ImageRIP Printer(s) dialog box (if
