T E CH N I C A L S U P P O RT:
1.800.283.5936 (USA) OR 1.801.975.3760
O P E R AT I O N •
FRONT PANEL
41
Muting or Unmuting Output
1.
Determine the output you want to mute.
2.
Press the OUTPUTS button, and scroll to the desired output channel.
Press ENTER.
3.
Scroll through the output parameters until you see MUTE. Press
ENTER.
4.
Use the
▲
and
▼
buttons to select ON, then press ENTER.
The output is now muted. To unmute the output, follow the same proce-
dure, but select OFF to deactivate the mute function.
Answering a Call
An incoming call rings on the telephone set connected to the AP400
and causes the ON LED to flash.
There are four ways to answer an incoming call:
1.
Set AUTO ANSWER ON to answer the call automatically.
2
. Set AUTO ANSWER OFF and press the Telephone/ON button to
answer the call manually.
3
. Send a serial command (for example, #30 TE 1) through the RS232
port (see AP400 Serial Commands).
4
. Pick up the telephone handset to answer manually. When you’re
ready to connect the call to the AP400, press the Telephone/ON but-
ton or send the "#30 TE 1" serial command.
To answer a call on the AP400, press the ON button on either the front
panel or from the RS232 port (#30 TE 1). The green ON LED lights. The
red OFF LED turns off.
To answer the call yourself, just pick up the handset. Then press ON to
put the caller onto the AP400, or type #30 TE 1 from the RS232 port.
Auto-Answer Note:
If AUTO ANSWER is turned
ON under SYSTEM settings,
the AP400 answers the call after the
first complete ring.
✍ ✍
NOTE: When using the DIAL
serial port command, the
AP400 automatically
engages the hybrid, you do not
need to press the ON button.
✍ ✍
