Genie GCL-J&H 1/2HP, Руководство по установке

Страница: 34 / 68

6.1
OPEN
CLOSE
STOP
CAL
RUN
SCROLL
SCROLL
SET
CLEAR
Section 6: Operator Setup Procedure
Operators include a full function control panel including a liquid crystal
display (LCD), calibration keys and Open, Close and Stop keys for on board
operator control. See Fig. 1. The open, close and stop keys function as a 3-button
wall control. The Display will show current operator conditions and calibration
information. Due to limited character space, some displays will be abbreviated.
See Appendix C (pgs. 10.11-10.13) for full display descriptions.
Operators include a non-volatile memory. The unit will remember all
calibration settings plus error code and run code logs, if power is removed from unit.
Control Operating Modes
Operator control boards operate in two modes: Run Mode and Calibration
Mode. The control board should normally operate in the Run Mode. The operator
is calibrated in Calibration Mode.
With the operator standing idle:
PRESS CAL/RUN TO TOGGLE BETWEEN OPERATING MODES.
• The first display in calibration mode is “SET CLOSE DIRECTION”
• The display in run mode will be one of the condition codes listed
in Appendix C.
Control Panel
Operation Keys, operate
unit like a 3-button
wall station.
Scroll Keys, used in
Calibration Mode.
Set/Clear Key, used to
reset and adjust
calibration settings.
Figure 1
Calibration & Run
Mode Toggle Key.
Display Backlighting
Toggle Key.
LCD DISPLAY
www.geniecompany.com 04-14
AFTER WIRING HAS BEEN COMPLETED, TURN ON POWER
TO THE OPERATOR.
DANGER:
After power is supplied to the operator,
Do Not make contact with components inside the control panel
except for the Keypad Keys. Fig. 1.
DANGER:
Après avoir mis l'opérateur sous tension, NE PAS
entrer en contact avec des composants à l'intérieur du panneau de
commande, sauf pour les touches du pavé numérique. Fig. 1.
WARNING:
DO NOT calibrate operator or operate
door unless doorway is in sight and free obstructions. Door will
move during setup. Keep people clear of opening while door is moving.
AVERTISSEMENT:
Calibrer l'opérateur et
utiliser la porte uniquement si la porte est en vue et libre de tout obstacle.
La porte se déplacera pendant la programmation. Ne laisser personne
se tenir dans l’ouverture de la porte pendant qu’elle est en mouvement.