Generac Power Systems G0071450, Руководство пользователя

Страница: 26 / 48

Operation
20 Owner’s Manual for 50 Hz Air-Cooled Generator Sets
Menu System Navigation
To get to the MENU, use the ESCAPE button from any page. If needed, press ESCAPE button several times to reach
MENU page. Navigate to desired menu by using
↑
/
↓
buttons. Press ENTER button when desired menu is displayed
and flashing.
Figure 3-5. Navigation Menu
EVOLUTION 2.0 / SYNC 3.0 HSB MENU MAP
Switched to “OFF”
Hours of Protection
0 (H)
Note: Menu functions and features may vary depending on unit model and firmware revision.
* Hours of Protection and number of hours will flash every 5 seconds when displayed.
*
Ready to Run
Hours of Protection
0 (H)
Utility Loss Delay
Pausing for 13 sec.
Cranking
Attempt # 3
Running in Exercise
Hours of Protection
0 (H)
Running
Cooling Down
Running - W
arning
“W
arning Message”
W
arning Message(s)
Low Battery
Exercise Set Error
Service Schedule
A
Service Schedule B
Inspect Battery
Stopping...
FIRMW
ARE ERROR-9
Fuel Pressure
Battery Problem
Charger W
arning
Charger Missing
AC
Overload W
arning
SEEPROM ABUSE
USB W
arning
Download Failure
Overload W
arning
No WIFI Module
No WIFI Router Comms
No WIFI Server Comms
Cranking - W
arning
“W
arning Message”
Alarm Message(s)
High Engine
T
emp
Low Oil Pressure
Overcrank
Overspeed
RPM Sense Loss
Underspeed
Controller Fault
FIRMW
ARE ERROR-7
WIRING ERROR
Overvoltage
Undervoltage
Overload Remove Load
Low V
olts Remove Load
Stepper Overcurrent
Auxiliary Shutdown
Emergency Stop
Fuse Problem
Loss of Speed Signal
Loss of Serial Link
Stopped - W
arning
“W
arning Message”
Cranking
Pausing for 13 sec
Running
Hours of Protection
0 (H)
Running
W
arming Up
Running -
Alarm
“Alarm Message”
Cranking -
Alarm
“Alarm Message”
Switched OFF
Hours of Protection
0 (H)
UP
ARROW
=
+
DOWN ARROW
=
-
006667