RS5-34 Telescopic Handler
INNER BOOM
PRINTED IN U.S.A.
703-3
913241
Alt= to hide template information
Alt+ to display template information
Template Name: OML_2_col
Rac 0-00000
Template Date: 1997_02_12
STEP 3
Push the inner boom into the intermediate boom 2 to
3 inches (50 - 76 mm) to relieve tension on the single
chain.
STEP 4
G0905025
Remove the front pivot pin from the extend cylinder.
See Section 608 of this manual for correct procedure.
STEP 5
G1005039
Loosen and remove the two bolts (1) and washers
that secure the single chain clevis block (2) to the
outer boom.
STEP 6
G0805199
Remove the four bolts (1) and the boom rear access
cover (2).
STEP 7
G1005040
Use a crow-foot wrench with a long extension to
reach in and loosen the locking nut on the chain
clevis. Once the locking nut is loosened, push the
clevis forward and remove both nuts from the clevis.
Do not remove the single chain from the machine.
IMPORTANT:
If the slide pads are to be reused, they
must be marked as to location and direction (front/
rear/top/bottom) as they are removed. Wire tie the
shims with each pad. Slide pads and shims must be
reinstalled in their exact original positions. Refer to
Section 707 of this manual for the correct procedure
to install new replacement slide pads.
1
1
2
2
1
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com
