RS5-34 Telescopic Handler
REAR AXLE
PRINTED IN U.S.A.
502-5
913241
Alt= to hide template information
Alt+ to display template information
Template Name: OML_2_col
907871E
Template Date: 1997_02_12
STEP 21
Remove the support stands from under the axle and
lower the axle to the floor. Torque the wheel nuts to
450 ft.-lbs. (610 Nm).
STEP 22
G0905136
W i th the re a r o f th e m ach i ne ra is ed , h ave an
assistant balance the axle using a long pipe or bar
i n s er te d i n t he eye - b ol t i n st al l e d o n th e a xl e
a ssem bly wh il e rol li ng the axl e asse m bl y into
position.
STEP 23
G0905060
Place two 10-ton hydraulic bottle jacks under the
frame in the location shown. Apply upward pressure
until the jack stands are clear.
STEP 24
Adjust th e jackstands to allow the frame to be
lowered onto the axle assembly.
STEP 25
Lower the jacks and align the mounting bolt holes in
the axle with the holes in the frame. Install the two
m ou n ti ng b o lts w ith n ew Ny l ock
®
nu ts i n t he
mounting holes on the front side of the axle. Do not
tighten at this time.
STEP 26
Align the rear mounting bolt holes in the axle with the
holes in the frame. Install the two mounting bolts with
new Nylock
®
nuts in the mounting holes at the rear
of the axle. Torque the front and rear axle mounting
bolts to 380 ft.-lbs. (515 Nm).
STEP 27
Remove the jack stands and the two bottle jacks.
STEP 28
Remove the caps and plugs from the hydraulic and
brake fittings and hoses.
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com
