PRINTED IN U.S.A.
703-1
913241
Alt= to hide template information
Alt+ to display template information
Template Name: OML_2_col
Rac 0-00000
Template Date: 1997_02_12
RS5-34 Telescopic Handler
INNER BOOM
MANDATORY SAFETY SHUTDOWN
PROCEDURE
BEFORE cleaning, adjusting, lubricating, or
servicing this unit:
1. Stop machine on a level surface. (AVOID parking
on a slope, but if necessary, park across the
slope and block the tires.)
2. Fully retract the boom and lower the attachment
tool to the groun d. Id le en gi ne for gra dua l
cooling.
3. Place controls in neutral and apply parking
brake.
4. Shut off the engine and remove the key.
ONLY when you have taken these precautions
can you be sure it is safe to proceed. Failure to
follow the above procedure could lead to death or
serious bodily injury.
RELIEVE HYDRAULIC OIL PRESSURE
1. Engage the park brake.
2. Lower equipment to the ground. Return the
engine to idle for 30 seconds, then shut off the
engine.
3. Turn the key switch on. Operate the joystick in
e a c h d i r e c t i o n . C o n f i r m t h a t t h e r e i s n o
atta chm ent or unit m ovem en t. Th is shoul d
ensure there is no residual pressure trapped in
the control circuit.
RELIEVING HYDRAULIC PRESSURE
FROM THE TILT CYLINDER
1. Remove any attachments from the boom.
2. Extend boom approximately 12 inches and lower
the boom onto a support stand.
3. Turn the key switch to the OFF position to shut
down the engine. (See above Mandatory Safety
Shutdown Procedure.)
G0805076
4. Remove the rear hood to allow access to the
main control valve.
G0805101
5. Locate the attachment Tilt-Up section (rear
section) on the left side of the control valve and
remove the rubber boot. Using a screwdriver,
turn the screw IN (clockwise) until it bottoms,
then tur n it OUT (counterclockwise) until it
bottoms. Reinstall the rubber boot.
View thousands of Crane Specifications on FreeCraneSpecs.com
View thousands of Crane Specifications on FreeCraneSpecs.com
