Installation Instructions
Range
If you have questions, call 1.800.GE.CARES
or
visit our Website at:
www.GEAppliances.com
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Canada, installation must conform
with the current Natural Gas Installation Code,
CAN/CGA-B149.1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified by
CSA International according to ANSI Z21.1, latest
edition and Canadian Gas Association according to
CAN/CGA-1.1 latest edition.
As with any appliance using gas and generating heat,
there are certain safety precautions you should follow.
You will find these precautions in the
Important Safety
Information
section in the front of this manual. Read
them carefully.
•
IMPORTANT –
Save these instructions
for local electrical inspector’s use.
•
IMPORTANT –
Observe all governing
codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these instructions for
future reference.
•
Note –
This appliance must be properly grounded.
•
Servicer –
The electrical diagram is in an envelope
attached to the back of the range.
•
Skill level –
Installation of this appliance requires basic
mechanical skills.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or
other flammable vapors and liquids in the vicinity of this
or any other appliance.
If you smell gas:
Open windows.
Don’t touch electrical switches.
Extinguish any open flame.
Immediately call your gas supplier.
TOOLS YOU WILL NEED
MATERIALS YOU MAY NEED
• Gas line shut-off valve
• Pipe joint sealant or UL-approved pipe thread tape
with Teflon* that resists action of natural and LP gases
• Flexible metal appliance connector (1/2
″
I.D.)
A 5-foot length is recommended for ease of installation
but other lengths are acceptable. Never use an old
connector when installing a new range.
• Flare union adapter for connection to gas supply line
(3/4
″
or 1/2
″
NPT x 1/2
″
I.D.)
• Flare union adapter for connection to pressure
regulator on range (1/2
″
NPT x 1/2
″
I.D.)
• Liquid leak detector or soapy water.
• Lag bolt or 1/2
″
O.D. sleeve anchor (for concrete
floors only).
*Teflon: Registered trademark of DuPont
Flat-blade screwdriver
Pipe wrenches (2)
(one for backup)
Phillips screwdriver
Open-end or
adjustable wrench
Pencil and ruler
Level
In the Commonwealth of Massachusetts:
•
This product must be installed by a licensed plumber
or gas fitter.
•
When using ball-type gas shut-off valves, they shall be
the T-handle type.
•
A flexible gas connector, when used, must not exceed
3 feet.
Drill, awl or nail
PART INCLUDED
Anti-Tip bracket kit
33