Troubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
46
Before you call for service…
Problem
Possible Causes
What To Do
“LOCK DOOR” flashes
The self-clean cycle has been
•
Close the oven door.
in the display
selected but the door is not
closed.
LOCKED DOOR light
The oven door is locked
•
Touch the
CLEAR/OFF
pad. Allow the oven to cool and
is on when you want
because the temperature
then, on models with a door latch, unlock the door.
to cook
inside the oven has not
dropped below the
locking temperature.
Oven door will not
Oven is too hot.
•
Allow the oven to cool below locking temperature.
unlock (on models
Do not lock the door with the door latch except when
with a door latch)
using the self-clean feature.
“Door” appears in the
Self-cleaning cycle has been
•
Move the latch handle all the way to the right.
display (on models
selected but the latch handle
with a door latch)
was not moved all the way
to the right.
Latch handle was moved to the
•
Move the latch handle to the right only when setting
right but a program other than
the self-cleaning cycle.
self-cleaning was selected.
“F—and a number or
On models with a door latch,
•
The latch may have been moved, even if only slightly,
letter” flash in the display
if a function error code appears
from the locked position. Make sure the latch is moved
during the self-cleaning cycle,
to the right as far as it will go.
check the oven door latch.
You have a function error code.
•
Touch the
CLEAR/OFF
pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats.
•
Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Display goes blank
A fuse in your home may be
•
Replace the fuse or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is in the
•
See the
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure.
•
Reset the clock.
Unable to get the
Oven control pads were
•
The
BAKE
and
BROIL HI/LO
pads must be touched at
display to show “SF”
not touched properly.
the same time and held for 3 seconds.
Power outage,
Power outage or surge.
•
Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the
CLEAR/OFF
pad, setting the clock and
resetting any cooking function.
Oven shelves are
The nickel shelves (if so equipped)
•
Apply a small amount of vegetable oil to a paper
difficult to slide
were cleaned in a self-clean cycle.
towel and wipe the edges of the oven shelves with
The gray porcelain-coated shelves
the paper towel. Do not spray with Pam
®
or other
(if so equipped) were improperly
lubricant sprays.
cleaned.
