6.3
Start a method run
Introduction
This section describes how to start a run using a previously created method. If Column
Logbook was enabled during installation of the software, registration and selection of
individual columns is possible at method start. For further information on method creation,
please refer to UNICORN Method Manual.
Choose and start a method
The following instructions describe how to open a method and start a run.
Action
Step
Open the System Control module and click the Open Method Navigator
button.
1
Result: The Method Navigator pane opens.
Select the method to run, and click the Run button.
2
Result: The Start Protocol dialog box opens.
Step through the displayed pages in the Start Protocol, add requested input
and make appropriate changes if necessary. Click Next.
3
136
ÄKTA avant Operating Instructions 29101556 AB
6 Run a method
6.3 Start a method run