– 19 –
Hook
Spring
Lever
Roller
Cam
Note:
Each door closer cam can be installed
incorrectly. Ensure each cam is installed on the
bottom of the drawer with the hooked end towards
the center of the drawer.
Bottom View of Drawer and Right Side Cam
Bottom of Drawer
Lower Freezer Drawer Closure Mechanisms
Two self-closing freezer drawer cam and lever
mechanisms automatically pull the lower freezer
drawer shut when it is within 1 inch of the closed
position. The closure mechanisms are located on
the lower corner areas of the drawer and cabinet.
Each closure mechanism consists of a lever, spring,
and cam. The lever is attached with a spring to a
hook in the base channel. The cam is attached to
the bottom of the drawer with two T-20 Torx screws.
The lever interacts with the cam to complete the
closing of the drawer.
A pair of pliers can be used to remove the spring
from the hook. The spring and lever can then be
pulled out through the hole in the base channel.
Door Alignment
If the top of the doors are uneven,
fi
rst try to raise
the lowest door by turning the leveling leg on the
same side as the door until the doors are even. If the
unit rocks, re-adjust the leveling legs until the unit is
stable.
If the doors remain uneven, turn the adjustable pin
to raise or lower the left door to match the right
door. Use a 1/4-in. Allen wrench to turn the pin.
Upper Freezer Drawer Closure Mechanisms
The upper freezer drawer utilizes 2 closure
mechanisms that automatically pull the drawer shut
when it is within 1 inch of the closed position. The
mechanisms are built into the 2 upper drawer rail
assemblies and are not replaceable as a separate
part.
Adjustable Pin
Upper Drawer Closure Mechanism
