GatesAir PT-353, Инструкция по установке и эксплуатации, Страница: 41 / 55

4 – Remote Configuration & Operation PT/PR-353 Module Installation & Operation Manual
Version 1.1
GatesAir 4-11
Intraplex Products
Table 4-5. PT-353 Transmitter Remote Status Messages (S Codes)
S
Code Parameter
Binary Digits
Value Description 7 6 5 4 3 2 1 0
LOCAL When active, indicates module is under
remote control
ALERT When active, indicates alert condition of
module
FAIL When active, indicates module hardware
failure
S01 Configuration
Error
B 0 0 0 0 0 0 0 0

0 Turn service on (enable module)
1 Configuration error exists. The card
configuration requires more time slots
than the multiplexer has available or the
time slots are not configured properly
(Section 3.3.3).
Backplane
Timing
B 0 0 0 0 0 0 0

0 0 T1 (1.544 MHz)
1 2MB (E1, 2.048 MHz)
Audio Activity B 0 0 0 0 0 0

0 0 0 No audio activity detected in left channel
1 Audio activity detected in left channel if
the signal is -28 dBFS.
Audio Error B 0 0 0 0 0

0 0 0 0 No audio errors detected.
1 AES/EBU error detected (Table 3-7).
B 0 0 0 0

0 0 0 0 0 Not used
Audio Source B 0 0 0

0 0 0 0 0 0 Analog input is in use.
1 Digital input is in use.
S01 B 0

0

0 0 0 0 0 0 0 Not used
S02 Audio Level B 0 0 0 0 0

0

0

0

0 or 1 Right channel audio level
(Table 4-4 binary values)
B 0

0

0

0

0 0 0 0 Left channel audio level
(Table 4-4 binary codes)
S03 DSP Firmware
Version
B 0 0 0 0 0 0 0 0

0 or 1 An 8-bit value indicating the DSP
firmware version
S04 FPGA Design
Version
B 0

0

0

0

0

0

0

0

0 or 1 An 8-bit value indicating the FPGA
design version
S05 B 0

0

0

0

0

0

0

0

0 Not used