GatesAir Intraplex NetXpress, Инструкция по установке и эксплуатации

Страница: 44 / 163

Intraplex NetXpress IP Multiplexer 3—Installation and Wiring
Version 3.05
3-6 GatesAir, Inc.
Intraplex Products
Table 3-2. SCB Switch Settings for TDM Channel Modules
Card
Address
SCB Switch Setting*
1 2 3 4 5 6
1 0 0 0 0 0 1
2 0 0 0 0 1 0
3 0 0 0 0 1 1
4 0 0 0 1 0 0
5 0 0 0 1 0 1
6 0 0 0 1 1 0
7 0 0 0 1 1 1
8 0 0 1 0 0 0
9 0 0 1 0 0 1
10 0 0 1 0 1 0
11 0 0 1 0 1 1
12 0 0 1 1 0 0
* 0 = OFF, 1 = ON
Note: Remove a module from the shelf when changing the SCB address.
3.8.4 Channel Module Insertion
To install a TDM channel module, orient the ejector tab toward the bottom of the shelf and slide the
module into the desired slot on the front of the shelf until it meets the connector on the front of the
midplane. From the rear of the shelf, slide the module adapter into the corresponding connector on
the back of the midplane.
Warning! Do not attempt to install TDM channel modules upside down. The Eject Tab (Figure 3-5)
should be at the bottom when the module is inserted.
Figure 3-5. Side View – TDM Channel Module and Module Adapter Insertion
Warning! Hot Insertion or Removal of a module adapter while a channel module is in place is not
recommended, as it could damage the channel module or the module adapter. To remove
a module adapter while the system is on (has power), first remove the associated channel
module. Similarly, to install a new channel module, first install the module adapter and
then install the module itself.
Verify that all modules (NIM-1, CAM, TDM channel modules, and power modules) are seated securely
in position.