99
Proximity Alarm—
You have entered the alarm
radius for the proximity waypoint indicated.
Proximity List Full—
You have used all nine
proximity waypoints.
Proximity Overlaps Another Prox Wypt—
The
alarm radius specified overlaps the area specified
for another proximity waypoint. (See section 10
for more information on proximity overlaps.)
RAM has Failed—
The random access memory
has failed and the unit is not operable. Take your
unit to an authorized GARMIN service center for
repairs.
ROM has Failed—
The unit’s permanent memory
has failed and the unit is not operable. Take your
unit to an authorized GARMIN service center for
repairs.
Received Invalid Waypoint—
A waypoint was
received during upload transfer that has an invalid
identifier.
Receiver has Failed—
A failure in receiver hard-
ware has been detected. If this message persists,
do not use the unit and take it to an authorized
dealer for repair.
Route Already Exists—
The route number you
are trying to copy to is already used.
Route Does Not Exist—
The route number you
are trying to use or copy is not defined.
Route is Full—
You have attempted to add more
than 30 waypoints to a route.
Route Memory is Full—
You have attempted to
create more than 20 routes.
Route Waypoint was Deleted—
A route way-
point entered does not exist in the database and
has been deleted from the route.
RTCM Input has Failed—
DGPS data being
received has been lost. You are no longer receiv-
ing the beacon signal.
Searching the Sky—
The GPSMAP 235 Sounder
is searching the sky for almanac data.
Shallow Water Alarm—
The depth is equal to or
less than the set alarm depth.
Sonar ASIC has Failed—
The unit’s internal
monitoring system indicates a malfunction. Send
in for service as soon as possible.
Sonar Transfer Timeout—
The sonar is inter-
mittently losing data. Sonar is usable but should
be returned for service is the message persists.
Stored Data was Lost—
All waypoints, routes
and almanac data has been lost due to internal
battery failure.
There is No RTCM Input—
The beacon receiver
is not properly connected or baud rates do not
match.
Timer Has Expired—
The countdown timer has
expired.
Track Memory is Full—
The track memory is
full and no additional track plot will be recorded
until the track memory has been cleared or set to
wrap mode.
Unit Too Hot Sounder Turned Off—
The inter-
nal temperature of the unit is too hot. GPS will
remain operational but the depth sounder func-
tion is turned off. To restore sounder operation,
turn off unit and allow unit to cool by shading
from direct sunlight. Note: To avoid this message
use a DC voltage source less than 16 volts.
Wypt Already Exists—
The waypoint name
you’ve entered already exists in memory.
Waypoint Memory is Full—
You have used all
250 waypoints in the GPSMAP 235 Sounder sys-
tem.
SECTION
C
APPENDIX
Messages
19000138.10A.QXD 11/11/99 8:47 AM Page 99
