A-3
Proximity wpt moved - One or more proximity waypoints were moved at
least 0.33 arc minutes due to a database change.
Received Invalid Wpt - A waypoint was received in an upload/transfer
operation that has an invalid identifier or position.
Receiver Failed - The GPS 95 has detected a failure in the receiver
hardware. If the message persists, the GPS 95 is unusable and should be
taken to an authorized GARMIN service center.
ROM Failed - The GPS 95 has detected a failure in its permanent memory.
If this message occurs, the unit is unusable and should be taken to an
authorized GARMIN service center.
Route is Full - An attempt has been made to add more than 30 waypoints
to a route. The GPS 95 will not allow more than 30 waypoints per route.
Route Not Empty - An attempt has been made to copy a route to a non-
empty route. The GPS 95 will not allow you to copy a route to a non-empty
route.
Route Waypoint - An attempt has been made to delete a waypoint which is
a member of one or more routes. You must remove the waypoint from all
routes before the waypoint can be deleted.
Route Wpt Deleted - A waypoint in a transmitted route does not exist in the
database and has been deleted from the route.
RTCM Input Failed - The GPS 95 was receiving RTCM inputs, but the data
signal has been interrupted.
Searching the Sky - The GPS 95 is in the search-the-sky mode. Allow the
unit to complete its data collection before turning it off. This process takes
approximately 15 minutes.
Start altitude chng - The altitude change entered on the VNAV Page is
about to begin.
Steep Turn Ahead - This message appears approximately one minute prior
to a turn that requires a bank angle in excess of 25 degrees in order to stay
on course.
Stored Data Lost - Stored user data, including waypoints, routes, and
satellite orbital data has been lost due to a low memory battery.
Timer Expired - The count down timer has expired.
