Document: GAR_SM_4601777 (4/16)
75
Section 7
Component Check Procedures
REPLACEMENT OF SHAFT SEAL & CAP O-RING
PROCEDURE
1. Ensure that the
platen is in the down
position, by pressing
green button.
2. Turn power OFF
using the main
power switch.
Green light
indicates
that the
Grill power
is “ON”
3. Remove the two
bolts holding the arm
pins in place at the
back of the platen.
Do not fully remove
them from the arm.
4. Tap the two pins
out as shown in the
illustration, and store
them in a save place.
Store the pin and
bushing in a safe
place.
5. Carefully
moved
the arm aside, place
close attention to
the conduit, do not
stretch the conduit
while moving the
platen.
6. Remove the knuckle
using an allen key
to remove the fi rst
set screw from the
assembly. then
remove the second
set of screws before
the knuckle can be
removed.
7. Remove the knuckle and store it with tha allen
screws in a save place.
8. Remove the three bolts attaching the cap seal to
the shaft. Slide the cap seal off the shaft.
9. Replace the shaft
seal and cap o-ring
by a new one. Grease
the shaft seal and
cap o-ring with food
grade before sliding
back onto the shaft.
10. Reinstalll the shaft
cap back over the
shaft and tighten
down loosely, the
over tight will be at
the last step.
11. Reinstall the fi rst
allen screw pin (A)
and tighten down
then insert second
allen screw and
tighten down to jam
the pin.
Содержание XPE12
Страница 2: ...THIS PAGE INTENTIONALLY LEFT BLANK ...
Страница 93: ...Document GAR_SM_4601777 4 16 93 Section 9 Diagrams ...