Gardner Denver ELECTRA-SAVER G2, Руководство по эксплуатации и обслуживанию

Страница: 37 / 100

13-21-611 Page 36
4-4
Inlet Valve , Figure 1-4 page 10 and Figure 4-2) - The Inlet valve restricts the inlet to control delivery and
closes to unload the compressor. At shutdown, the inlet valve closes to prevent the back flow of air.
The inlet valve position is controlled by air pressure in its piston cylinder, which is controlled by the AirSmart
G2 Controller through solenoid valves IVC and IVO. As Pressure to the piston is increased, the valve
closes to restrict air flow and compressor delivery.
Solenoid Valves IVC and IVO - These valves control position of the inlet valve in response to signals from
the AirSmart G2 Controller. With both valves de-energized, the normally open IVC valve allows control
pressure to the inlet piston to close the valve. If IVC only is energized, the inlet valve is held in its current
position. If both valves are energized, control pressure is relieved from the inlet piston to allow the valve to
open.
Pressure Regulator - The pressure regulator is used to supply a constant and low control pressure to
prevent damage to the inlet valve from “slamming". The regulator should be set for 60 psig.
Shuttle Valve (Figure 4-2) - Also known as a double check valve, the shuttle valve is a device which will
take two (2) supply signals and allow the one with the highest pressure to pass through. The shuttle valve
is used to provide control air pressure from either the reservoir or plant air system, as required during
different operating conditions.