Gantner GAT NET.Lock 7000, Установка, настройка и эксплуатация

Страница: 17 / 40

GAT NET.Lock 7000 System
Mounting
www.gantner.com
HB_GAT-NETLOCK7000--EN_30
17
- If right and left doors are used in a mix, please note the LED positions, since the GAT NET.Lock 7000 is mounted
upside-down on the left doors, compared to the right doors.
Figure 3.6 - LED positions of GAT NET.Lock 7000 at right and left doors
Before mounting all locks of the locker system a test installation of one lock in a mechanically finalized locker
and a subsequent function check must be performed like described below. Only if this check is successful,
the rest of the locks may be mounted in the same way!
3.5.2 Steps for Mounting of the GAT NET.Lock 7000 at Non-Metallic Doors
Please perform the following steps in order to mount the GAT NET.Lock 7000 at non-metallic doors.

Drill the 3 holes (3) for the GAT NET.Lock 7000 into the locker wall.
Attention: Position the 3 holes according to the information in "3.5.1. Important Measures when Mounting
the GAT NET.Lock 7000 and Bolt Set (Non-Metal Doors)"!

Plug-in the connection cable at the GAT NET.Lock 7000 (see "4. Electrical Connection").

Mount the GAT NET.Lock 7000 with 3 screws (3) on the inside locker wall.
Note: Use the right screws according to the type of locker material
Attention: The max. allowed tightening torque of the screws is 2 Nm.

Drill the 3 holes (6) on the locker door inside for mounting the GAT NET.Lock BoltSet 7100.

Drill a hole for the LED display in the locker door (7). The recommended hole diameter is 10 mm.
Note: A customer-specific front label can be used to cover the LED hole. A transparent (matt) field should be placed
on the label to show the LED light.

Mount the bolt set onto the inside of the locker door by using 3 screws.
Note: Use the right type and length of the screws according to the type of locker material.

Close the door to test, if the locker door can be closed easily and the door shackle inserts into the opening in the
GAT NET.Lock 7000.