Gantner GAT NET.Lock 7000, Установка, настройка и эксплуатация

Страница: 3 / 40

GAT NET.Lock 7000 System
www.gantner.com
HB_GAT-NETLOCK7000--EN_30
3

Copyright 2013, GANTNER Electronic GmbH, Schruns (Austria).
General warning and safety instructions
Dear customer,
we congratulate you on having selected a product (device resp. software) of GANTNER Electronic GmbH. So that our product
functions in your installation with safety and to your complete satisfaction, we take this opportunity to familiarise you with the following
ground rules:
1. Installation, commissioning, operation and maintenance of the product purchased must be carried out in accordance with in-
structions, i.e. in accordance with the technical conditions of operation, as described in the corresponding product documenta-
tion.
2. Before installation, commissioning, operation or maintenance it is therefore essential that you read the corresponding chapter
of this manual and observe its instructions.
3. If there are still some points, on which you are not entirely clear, please do not take a chance, but ask the customer adviser
responsible for you, or ring the GANTNER Electronic GmbH hotline.
4. Where not otherwise specifically laid down, appropriate installation, commissioning, operation and maintenance of the product
is the customer’s responsibility.
5. Directly on receipt of the goods, inspect both the packaging and the device resp. data carrier itself for any signs of damage.
Also check that the delivery is complete (-> accessories, documentation, auxiliary devices etc.).
6. If the packaging has been damaged in transport or should you suspect that it has been damaged or that it may have a fault, the
product must not be put into service. In this case, contact your customer advisor. He will make every effort to resolve the
problem as quickly as possible.
7. Installation, commissioning and servicing of our appliances must only be carried out by suitably trained personnel. In particular,
electrical connections may only be made by correspondingly qualified specialists. Here, the appropriate installation provisions
in accordance with the relative national Electrical Engineers construction regulations (e.g. ÖVE, [Austrian] VDE, [German]...)
must be observed.
8. Where not otherwise stated, installation and maintenance work on our appliances is exclusively to be carried out when discon-
nected from the power supply. This applies in particular to appliances which are normally supplied by low-tension current.
9. It is prohibited to make alterations to the appliances or to remove protective shields and covers.
10. Do not attempt yourself to repair an appliance after a defect, failure or damage, or to put it back into operation again. In such
cases, it is essential you contact either your customer adviser or the GANTNER Electronic GmbH hotline.
11. GANTNER Electronic GmbH accepts no responsibility for any injuries or damage caused as a result of improper use.
12. Although every care is taken and we are continuously aiming for improvement, we cannot exclude completely the possibility of
errors appearing in our documentation. GANTNER Electronic GmbH therefore accepts no responsibility for the completeness
or the accuracy of this manual. The right is reserved to make alterations, and we may carry out alterations at any time without
giving prior notice.
13. Should you discover any fault with the product or in its accompanying documentation, or have any suggestions for improvement,
you may confidently approach either your customer adviser or GANTNER Electronic GmbH directly.
!