Gantner GAT NET.Lock 7000, Установка, настройка и эксплуатация

Страница: 31 / 40

GAT NET.Lock 7000 System
Configuration and Operation
www.gantner.com
HB_GAT-NETLOCK7000--EN_30
31
5. CONFIGURATION AND OPERATION
5.1 Antenna Adjustment of the GAT NET.Lock 7000
The antenna of the GAT NET.Lock 7000 needs to be adjusted so that the optimal reading range for the RFID data
carriers is optained. The antenna adjustment
doesn’t need to be made by hand, the GAT NET.Lock 7000 supports
automatic antenna adjustment via PC software.
The antenna adjustment of a lock is also possible with the MODE button of the Slave Controller, where the lock is
connected (see "4.3.4. LED Signals and Buttons").
Note: The locker door must be closed during the antenna adjustment so that the test conditions meet the later oper-
ating conditions.
Proceed with these steps:
-
Close all locker doors.
- Press MODE button once.
-> The antenna adjustment is completed in less than 1 second.
5.2 Locker Operation by the Visitor
5.2.1 Lock a Locker
In order to use an unused locker (i.e. locking a locker) the door must be pressed shut so that the door shackle moves
into the GAT NET.Lock 7000. While the door is kept shut the user must hold his data carrier to the reading field on
the locker door. The GAT NET.Lock 7000 reads the data carrier, communicates with the slave and master controllers
and if the data carrier (i.e. the user) is allowed to use the locker, a command will be sent so that the GAT NET.Lock
7000 will lock the locker.
With a push button at the front of the GAT NET.Lock 7000 the lock detects, if the locker door is closed or not. This
allows indication of the locker status by a PC software.
5.2.2 Unlock and Open a Locker
When a user wants to open a locker, the user must identify himself at the lock with his RFID data carrier. As soon as
the user holds his data carrier to the RFID scan field the GAT NET.Lock 7000 reads the data carrier, communicates
with the slave and master controllers and if the data carrier (i.e. the user) is allowed to open the locker, a command
will be sent so that the GAT NET.Lock 7000 will unlock the locker.